Made in China
Computerized Bench Top Cold Storage Trainer
The trainer features a large refrigeration chamber.
Two evaporators allow for an investigation of the effect of different evaporator sizes on the cold storage room climate and the icing.
An electric defrost heater and hot gas defrosting are available.
The defrost process can be performed as required using a defrost controller or at set intervals using a defrost timer.
Two adjustable heat sources in the refrigeration chamber simulate the cooling load.
One of these heat sources generates water steam to simulate the introduction of humidity into the refrigeration chamber.
The measured values can be read on digital displays.
At the same time, the measured values can also be transmitted directly to a PC via USB.
The data acquisition software is included.
The data acquisition enables e.g. the recording of the defrosting process over time and the online representation of the climate in the refrigeration chamber in the h-x diagram.
The flow rate of the refrigerant is determined by means of the pressure measurement.
FEATURES:
Effect of the evaporator size and temperature on the climate in the refrigeration chamber
Configuration of defrost controls such as defrost timer or defrost controller
Frosting and icing under different operating conditions
Difference between latent and sensitive cooling load
Different defrosting methods (electric heater, hot gas)
SPECIFICATION:
Compressor suitable capacity :
Refrigeration capacity at -5/55°C: 999W
Power consumption: 565W
Latent cooling load: 2x 0…250W
Sensitive cooling load: 1x 0…200W, 1x 0…250W
Receiver: 1,3L
Refrigerant: R134a/22/etc.
Filling volume: 1,3kg
CO2-equivalent: 0,8t
Measuring ranges :
Pressure: 2x 0…16bar, 1x 0…25bar
Temperature: 7x -50…150°C; 1x -25…125°C
Rel. humidity: 0…100%
Flow rate: 2…27L/h
Required for operation :
230V, 50Hz, 1 phase
230V, 60Hz, 1 phase
As leading computerized bench top cold storage trainer manufacturers, suppliers & exporters in China, Engineering Lab China combines factory-direct pricing, strict quality control and reliable worldwide shipping. Every Computerized Bench Top Cold Storage Trainer is built in-house in Guangzhou City to deliver dependable performance for engineering training and teaching environments.
We manufacture every Computerized Bench Top Cold Storage Trainer at our own facility in Guangzhou, China. No middlemen — you get factory pricing on Engineering Laboratory Trainer Kits, Training Charts and Educational Equipment.
Every Computerized Bench Top Cold Storage Trainer passes a strict outward quality check before dispatch, so it stands up to daily use in Industrial Training Institutions, Engineering Colleges & Polytechnics.
From a single trainer kit to a full lab tender, our team manages packaging and prompt international delivery so your Computerized Bench Top Cold Storage Trainer arrives on schedule, anywhere in the world.
EngineeringLabChina is a leading computerized bench top cold storage trainer manufacturers, computerized bench top cold storage trainer suppliers & exporters in China. Whether you need a single unit for a lab refresh or a complete tender for a polytechnic, we handle Engineering, Procurement, Installation and Commissioning under one roof.
We accept Wire or Telegraphic Transfer / Letter of Credit. Shipping is based on consignment size — contact us with your requirement for an accurate quote.
Share quantity, destination country and any custom specs for the Computerized Bench Top Cold Storage Trainer.
Our team replies with factory pricing, lead time and shipping options within 24 hours.
We manufacture in Guangzhou, run a quality check and prepare export-ready packaging.
Consignment dispatched by your preferred mode — sea, air or courier — to your door.
Full product category index — manufactured in Guangzhou, exported worldwide.
