Made in China
Orifice and Venturi Meter Demonstration
The equipment consists of a Venturi meter, variable area meter and orifice plate, installed in a series configuration to permit direct comparison.
A flow control valve permits variation of the flow rate through the circuit.
Pressure tappings are incorporated so that the head loss characteristics of each flow meter may be measured.
These tapping’s are connected to an eight-tube manometer bank incorporating a manifold with an air bleed valve.
A hand pump facilitates pressurization of the manometers.
The circuit and manometer are attached to a support framework, which stands on the working top of the Hydraulics Bench.
The bench is used as the source of water supply and for volumetrically calibrating each flow meter.
This enables to adjust the levels in the manometer bank to a convenient level to suit the system static pressure.
Venturi meter, variable-area meter and orifice plate with flow-control valve.
Determination of the Cd factor in the Venturi.
Determination of the strangulation in the Venturi.
Determination of the Cd factor in the orifice plate.
Determination of the error in flow measurements using the orifice plate.
Pressure tapping’s to measure head loss across each meter.
Quick-release fitting for easy connection to Hydraulics Bench.
Calibrating each flow meter using the volumetric measuring tank of the bench.
Comparing pressure drops across each device.
Directly comparing flow measurement using a Venturi meter, variable area meter and orifice plate.
Educational software available as an option.
Supplied with manometer board with eight tubes.
Manometer range: 0 to 500 mm. of water column.
Number of monomeric tubes: 8.
Orifice plate diameter: 25 mm.
Flow meter: 2to30 l./min.
Easy and quick coupling system built-in.
Anodized aluminum structure and panel of painted steel.
As leading orifice and venturi meter demonstration manufacturers, suppliers & exporters in China, Engineering Lab China combines factory-direct pricing, strict quality control and reliable worldwide shipping. Every Orifice and Venturi Meter Demonstration is built in-house in Guangzhou City to deliver dependable performance for engineering training and teaching environments.
We manufacture every Orifice and Venturi Meter Demonstration at our own facility in Guangzhou, China. No middlemen — you get factory pricing on Engineering Laboratory Trainer Kits, Training Charts and Educational Equipment.
Every Orifice and Venturi Meter Demonstration passes a strict outward quality check before dispatch, so it stands up to daily use in Industrial Training Institutions, Engineering Colleges & Polytechnics.
From a single trainer kit to a full lab tender, our team manages packaging and prompt international delivery so your Orifice and Venturi Meter Demonstration arrives on schedule, anywhere in the world.
EngineeringLabChina is a leading orifice and venturi meter demonstration manufacturers, orifice and venturi meter demonstration suppliers & exporters in China. Whether you need a single unit for a lab refresh or a complete tender for a polytechnic, we handle Engineering, Procurement, Installation and Commissioning under one roof.
We accept Wire or Telegraphic Transfer / Letter of Credit. Shipping is based on consignment size — contact us with your requirement for an accurate quote.
Share quantity, destination country and any custom specs for the Orifice and Venturi Meter Demonstration.
Our team replies with factory pricing, lead time and shipping options within 24 hours.
We manufacture in Guangzhou, run a quality check and prepare export-ready packaging.
Consignment dispatched by your preferred mode — sea, air or courier — to your door.
Full product category index — manufactured in Guangzhou, exported worldwide.
