Made in China
Plate Bearing Test
A Plate Bearing Test is a model test used for foundations.
It is used to determine the ultimate bearing capacity of the foundations by providing the load deformation characteristics.
In this test, a gradual increment of load is applied on the steel plate and the respective corresponding settlement is captured.
The ultimate 50 ton bearing capacity is taken as the load up to which the settlement increases at a rapid rate with separate pumping.
Plate Bearing Test unit fixed to it a 0 - 500KN x 0.5KN. 1No. Pressure gauge and flexible metal pipe 5 mtr. long 1No. ball and socket arrangement between the jack and the bearing plate 1 No and extension rod 12mm dia x 25 cm long for taking dial gauge readings 16 Nos.
Magnetic base with female thread on top for holding extension rod 4 Nos and end plate, 50mm, dia with male thread for fitting onto the extension rods and positioning the dial gauge plunger 4 Nos. 30 cms x 25mm.
It is a standard defined technique used to determine the bearing capacity of the solid which is calibrated and compared with the results of the other method against the values of the plate bearing test.
Specifications:
The Plate Bearing Test consists of the following:
A Pressure gauge and flexible one metal pipe 5 mtr. long
One special ball and socket for arrangement between the bearing plate and the jack.
One 5 mtr. long bridge support of welded steel angle construction.
Dial Gauge 0.01mm x 25mm.
16 Extension rod of 12 mm dia x 25 cm long for taking dial gauge readings.
4 magnetic base with a female thread on top to hold extension rod.
4 top end plate of 50mm dia with male thread for positioning the dial gauge plunger and fitting onto the extension rods.
2 column of 15cm dia x 25cm long with flanges complete with four bolts and nuts.
1 column of 15cm dia x 50cm long with flanges complete with four bolts and nuts.
Approx. 30 cm. high Span and stands that is Fitted with the two quick release clamps for positioning and holding the dial bracket (2).
60cms x 60cm Square x 60 cms. Square x 25mm thick plane M.S. plate.
45cm x 45cm x 25mm thick plane M.S. plate.
30 cms x 30 cms x 25mm thick plane M.S. plate.
As leading plate bearing test manufacturers, suppliers & exporters in China, Engineering Lab China combines factory-direct pricing, strict quality control and reliable worldwide shipping. Every Plate Bearing Test is built in-house in Guangzhou City to deliver dependable performance for engineering training and teaching environments.
We manufacture every Plate Bearing Test at our own facility in Guangzhou, China. No middlemen — you get factory pricing on Engineering Laboratory Trainer Kits, Training Charts and Educational Equipment.
Every Plate Bearing Test passes a strict outward quality check before dispatch, so it stands up to daily use in Industrial Training Institutions, Engineering Colleges & Polytechnics.
From a single trainer kit to a full lab tender, our team manages packaging and prompt international delivery so your Plate Bearing Test arrives on schedule, anywhere in the world.
EngineeringLabChina is a leading plate bearing test manufacturers, plate bearing test suppliers & exporters in China. Whether you need a single unit for a lab refresh or a complete tender for a polytechnic, we handle Engineering, Procurement, Installation and Commissioning under one roof.
We accept Wire or Telegraphic Transfer / Letter of Credit. Shipping is based on consignment size — contact us with your requirement for an accurate quote.
Share quantity, destination country and any custom specs for the Plate Bearing Test.
Our team replies with factory pricing, lead time and shipping options within 24 hours.
We manufacture in Guangzhou, run a quality check and prepare export-ready packaging.
Consignment dispatched by your preferred mode — sea, air or courier — to your door.
Full product category index — manufactured in Guangzhou, exported worldwide.
