Made in China
Computerized Reciprocating Pump Test Apparatus
The Computerized Reciprocating Pump Test Apparatus experimental unit provides the basic experiments to get to know the operating behavior and the important characteristic variables of piston pumps.
The test rig consists of a closed water circuit with water tank, a piston pumps with variable speed via a frequency converter and an air vessel.
The piston of the pump is mounted in a transparent housing and can be observed during operation.
The cycle that takes place (intake and discharge of water) can be shown clearly in the p-V diagram.
The pulsating pressure curve of the pump can be damped with the aid of the air vessel.
Flow rate and head are adjusted via a needle valve and overflow valve.
The experimental unit is fitted with sensors for pressure and flow rate.
One pressure sensor measures the pressure at the outlet of the pump; another one measures the pressure in the inside of the cylinder.
The position of the piston rod is measured by an angle sensor.
This allows the determination of the cylinder volume.
The microprocessor-based measuring technique is well protected in the housing.
The measured values are transmitted directly to a PC via USB where they can be analyzed using the software included.
FEATURES:
Principle of operation of a piston pump
Determination of efficiencies
Recording of pump characteristics
Pressure curves of delivery pressure and cylinder pressure
Influence of pulsation damping
SPECIFICATION:
Gear transmission ratio: 1=7,5
Piston pump :
Speed: 30…180min-1
Max. Flow rate: 135L/h
Max. Head: 40m
Drive motor :
Power: 180W
Measuring ranges :
Pressure (cylinder): 0…5bar
Pressure (outlet): 0…5bar
Crank angle: 0…360°
Flow rate: 0,2…6L/min
230V, 50Hz, 1 phase
230V, 60Hz, 1 phase; 120V, 60Hz, 1 phase
As leading computerized reciprocating pump test apparatus manufacturers, suppliers & exporters in China, Engineering Lab China combines factory-direct pricing, strict quality control and reliable worldwide shipping. Every Computerized Reciprocating Pump Test Apparatus is built in-house in Guangzhou City to deliver dependable performance for engineering training and teaching environments.
We manufacture every Computerized Reciprocating Pump Test Apparatus at our own facility in Guangzhou, China. No middlemen — you get factory pricing on Engineering Laboratory Trainer Kits, Training Charts and Educational Equipment.
Every Computerized Reciprocating Pump Test Apparatus passes a strict outward quality check before dispatch, so it stands up to daily use in Industrial Training Institutions, Engineering Colleges & Polytechnics.
From a single trainer kit to a full lab tender, our team manages packaging and prompt international delivery so your Computerized Reciprocating Pump Test Apparatus arrives on schedule, anywhere in the world.
EngineeringLabChina is a leading computerized reciprocating pump test apparatus manufacturers, computerized reciprocating pump test apparatus suppliers & exporters in China. Whether you need a single unit for a lab refresh or a complete tender for a polytechnic, we handle Engineering, Procurement, Installation and Commissioning under one roof.
We accept Wire or Telegraphic Transfer / Letter of Credit. Shipping is based on consignment size — contact us with your requirement for an accurate quote.
Share quantity, destination country and any custom specs for the Computerized Reciprocating Pump Test Apparatus.
Our team replies with factory pricing, lead time and shipping options within 24 hours.
We manufacture in Guangzhou, run a quality check and prepare export-ready packaging.
Consignment dispatched by your preferred mode — sea, air or courier — to your door.
Full product category index — manufactured in Guangzhou, exported worldwide.
