Made in China
Marsh Cone Funnel With Stand and Measuring Cylinder
Cone : A cone as shown. It will be robust and manufactured from G.I. (Can be manufactured in S.S. at extra cost)
Sieve : The sieve aperture will be about 1.5 mm and the sieve will be filled as shown in Figure and will be removable.
Stopwatch : The stop watch shall be accurate to 0.2 s in 60 s and shall show time to 0.1s (not included and available at extra cost)
Cylinder : A graduated Plastic cylinder of 1 liter capacity and diameter in the range 60mm to 150mm
Mount the cone with its axis vertical and its largest diameter uppermost.
Fix the sieving medium at the position indicated in figure B3.
During the test prevent the cone from vibrating.
Place the cylinder under the cone outlet .
All surfaces of the cone shall be clean and shall be dampened so that the surfaces are moist but without free water.
Close the lower cone orifice.
Pour the grout through the sieve to fill the conical section of the cone.
Pouring shall be sufficiently slow to prevent the build-up of air in the grout in the cone .
Open the lower cone orifice and the same time, start the stopwatch.
Measure the time taken to the nearest 0.5 s to fill the cylinder to 1 liter.
The Presence of lumps on the sieve shall be reported.
For suitability Testing, Three tests shall be carried out, the first immediately after the grout is mixed and the remaining two test at the estimated time to grout a duct or a minimum of 30 minutes after the grout is mixed.
The grout shall be kept agitated while awaiting testing.
As leading marsh cone funnel with stand and measuring cylinder manufacturers, suppliers & exporters in China, Engineering Lab China combines factory-direct pricing, strict quality control and reliable worldwide shipping. Every Marsh Cone Funnel With Stand and Measuring Cylinder is built in-house in Guangzhou City to deliver dependable performance for engineering training and teaching environments.
We manufacture every Marsh Cone Funnel With Stand and Measuring Cylinder at our own facility in Guangzhou, China. No middlemen — you get factory pricing on Engineering Laboratory Trainer Kits, Training Charts and Educational Equipment.
Every Marsh Cone Funnel With Stand and Measuring Cylinder passes a strict outward quality check before dispatch, so it stands up to daily use in Industrial Training Institutions, Engineering Colleges & Polytechnics.
From a single trainer kit to a full lab tender, our team manages packaging and prompt international delivery so your Marsh Cone Funnel With Stand and Measuring Cylinder arrives on schedule, anywhere in the world.
EngineeringLabChina is a leading marsh cone funnel with stand and measuring cylinder manufacturers, marsh cone funnel with stand and measuring cylinder suppliers & exporters in China. Whether you need a single unit for a lab refresh or a complete tender for a polytechnic, we handle Engineering, Procurement, Installation and Commissioning under one roof.
We accept Wire or Telegraphic Transfer / Letter of Credit. Shipping is based on consignment size — contact us with your requirement for an accurate quote.
Share quantity, destination country and any custom specs for the Marsh Cone Funnel With Stand and Measuring Cylinder.
Our team replies with factory pricing, lead time and shipping options within 24 hours.
We manufacture in Guangzhou, run a quality check and prepare export-ready packaging.
Consignment dispatched by your preferred mode — sea, air or courier — to your door.
Full product category index — manufactured in Guangzhou, exported worldwide.
